α-Cyanoacrylate adhesive series
Usage instruction
• Gelatinize: the surface of the material which is to be bonding must be clean and dry also it should be smooth. Then drop the glue, rubbing it a little to make the glue distribute equally. The thickness of the general type 'F' and the fast harden type 'S' should be lower than 0.1mm. Every drip can cover an area of 5-6c , , the quantity and the thickness of the gelatinize of the glue will be increased as the increase of the viscosity.
• The condition of the harden:
The adhesion will get tight in a few seconds, and the maximum strength can be obtained in 24 hours.
• Toxin and defend
It has the sharp odor but non-pollution, non-toxic. Pay attention to keep it in a well-ventilated area when use it.
| 
Previous
